If you are searching any gift for your loved one this decoration piece is the ideal one. You can decorate it on the wall and with its good look your lounge would look great. If you are giving a gift to your family members they would surely admire you and like this gift very much. This running deer is creating an outstanding impression on the people and they tend to have it on the wall of their lounge. It would fit best in the lobby too. I am sharing some of the pictures of this dear; just have a look at these pictures.
Lumber and supplies are moved in and out of the shop through the front overhead door. To the left of the door are the lumber and plywood storage racks. Across from the lumber rack and to the right of the overhead door is the radial arm saw, miter saw and mortise utilizing a single fence system for all operations. Below and above these are cabinets and storage for misc. power hand tools. Next to the radial arm saw and in the corner is the floor drill press with accessory storage next to it for all drilling operations.  Across from the radial arm saw is a separate workstation set up with a small portable table saw and router set-up with storage underneath for routers, bits and accessories.
To inset the aprons 3/4" from the outer surface of the legs I made a spacer from 2 pieces of plywood.  This little jig made it easy to keep the distances uniform and also secure the apron to the leg while fastening.  Pic 3 illustrates how the jig, apron and leg are clamped together for fastening.  Each apron end is held by three 2 1/2" pocket screws.  The pocket holes were made using a Kreg pocket hole jig.  I assembled the short ends first and then the rest of the table base making sure the kerf (for clips) was along the top edge.  Since this is a long table I also added a cross piece in the middle of the table using pocket screws.
×