For this lesson on milling lumber, we headed out to the Connecticut Valley School of Woodworking, where instructor Bob Van Dyke demonstrated the classic sequence used to prepare rough lumber with power tools. Sometimes referred to by the acronym "FEE" (faces, edges, ends) the sequence involves flattening one face of the board on a jointer and then creating a parallel, flat opposing face with a thickness planer. After the faces are flat and parallel, square one edge with a jointer and then rip the other edge parallel on a tablesaw. Finally, crosscut the board to length with a miter gauge on the tablesaw.
Sometimes Grandparents can be hard to buy gifts for, they seem to have everything already. But hey you can't go wrong with darling gifts of grand kids, right!?! In this post I'm going to share a couple of ideas for personalized photo gifts. To make the photo gifts, I will be using Photoshop Elements 2018. I have been using Photoshop Elements ever since I graduated from trying … [Read more...]