I feel really trouble for hanging my jewelry in a fine place. I think almost twice the time for this project and here in this image, you can see that I am successful in making DIY wooden art of jewelry hanging. This is different and elegant jewelry hanging project. You just need full concentration for making a perfect wooden art. The shape of jewelry hanging is tree style. You can put on your dressing table or at the side corner of the table in your room. For the full image, you need to check this link.
Hardwood boards and softwoods may look similar in shape and dimension, but they are sold using completely different measuring systems. Softwoods are typically sold in standard lumber dimensions (such as a 2x4), whereas hardwoods are most often sold by the board foot. Calculating board feet helps you guarantee that you're getting your money's worth on every piece of hardwood you purchase.
For the legs, we purchased black steel gas pipes which had to be measured and cut to size.  After the steel pipes were cut they had to be manually threaded with a pipe threader.  Gas fittings were used to connect the piping. This step resulted in a few choice bad words, it seems you can actually get them already threaded. But why should we take the easy route, when we can make ourselves crazy instead. 

To inset the aprons 3/4" from the outer surface of the legs I made a spacer from 2 pieces of plywood.  This little jig made it easy to keep the distances uniform and also secure the apron to the leg while fastening.  Pic 3 illustrates how the jig, apron and leg are clamped together for fastening.  Each apron end is held by three 2 1/2" pocket screws.  The pocket holes were made using a Kreg pocket hole jig.  I assembled the short ends first and then the rest of the table base making sure the kerf (for clips) was along the top edge.  Since this is a long table I also added a cross piece in the middle of the table using pocket screws.
×